GUARD AS 2777144 - Caterpillar

Accumulated grease and oil on a machine is a fire hazard. Remove this debris with steam cleaning or high pressure water, at least every 1000 hours or each time any significant quantity of oil is spilled on a machine.
Note: For maximum service life of the machine, make a thorough walk-around inspection before you operate the machine. Inspect the machine for leaks. Remove any debris from the engine compartment and the undercarriage. Ensure that all guards, covers, and caps are secured. Inspect all hoses and belts for damage. Make the needed repairs before you operate the machine.Perform the following procedures on a daily basis.
Operation and Maintenance Manual, "Backup Alarm - Test"
Operation and Maintenance Manual, "Braking System - Test"
Operation and Maintenance Manual, "Cooling System Level - Check"
Operation and Maintenance Manual, "Engine Air Filter Service Indicator - Inspect"
Operation and Maintenance Manual, "Engine Oil Level - Check"
Operation and Maintenance Manual, "Fuel System Water Seperator - Drain"
Operation and Maintenance Manual, "Hydraulic System Oil Level - Check"
Operation and Maintenance Manual, "Loader Bucket, Cylinder, and Linkage Bearings - Lubricate"
Operation and Maintenance Manual, "Seat Belt - Inspect"
Operation and Maintenance Manual, "Tire Inflation - Check"
Operation and Maintenance Manual, "Transmission Oil Level - Check"Refer to the Maintenance Section for the detailed procedures. Refer to the Maintenance Interval Schedule for a complete list of scheduled maintenance.General Machine Cleaning
Note: When using pressure washing equipment, wear safety glasses as well as protective clothing. High-pressure water can cause serious injuries.
Always make sure that steps and grab handles are clean and free dirt, grease, ice and other debris at all times.
Use a low-pressure water jet and brush to soak off caked mud, grease and dirt. Only use a pressure washer to remove soft dirt and oil.
Do not wash the machine with the engine running. Allow the engine to cool sufficiently before cleaning. When washing the engine keep a minimum distance of 60 cm (24.0 inch) from the engine components.
Do not use high-pressure washers with circular jet nozzles, or pencil nozzles. A fan nozzle is recommended when cleaning your machine.
Do not exceed 60° C (140° F) maximum water temperature.
Keep a minimum cleaning distance of 30 cm (12.0 inch) between the nozzle and machine surface at all times.
Observe manufactures guidelines when operating high-pressure cleaners.
Avoid high strength cleaning fluids. Use the solution with a "pH" value between 4 and 9. Follow the manufactures guidelines for diluting the detergent otherwise damage to the paint finish may occur.
Do not aim the water jet directly at electrical connections or other electrical components such as alternators or electronic control modules. Also take care around door seals, lights, oil seals, bearings, etc.
Do not concentrate the pressure on one spot. Keep the lance moving at all times.
After cleaning the machine, run the machine until it reaches the recommended operating temperatures.
Always grease all points on the machine after pressure washing. You may have washed grease out of important joints during the cleaning process.Paint Finish Maintenance
After cleaning the machine, inspect the paint finish for any damage such as chips, scratches and scuffs. Repair these