GUARD AS 4351862 - Caterpillar

Removal Procedure
Start By:
Remove the seat assembly.Note: Install caps and plugs on all openings in order to prevent dirt or debris from entering the system. Cleanliness is an important factor. Before the removal procedure, the exterior of the component should be thoroughly cleaned. This will help to prevent dirt from entering the internal components.Note: For easier assembly, mark all hose assemblies, tube assemblies, wire harnesses and cables for identification purposes.
Illustration 1 g00636985
Remove shift knob (1) from the shift knob lever.
Remove four bolts (2) from cover (3) .
Remove cover (3) from the control panel.
Remove six bolts (4) from front cover (5) .
Remove cover (5) from the control panel.
Illustration 2 g00636986
Remove two knobs (6) from side panel (9) .
Remove two bolts (7) and cap (8) from side panel (9) .
Remove side panel (9) from the control panel.
Illustration 3 g00636988
Remove four bolts (10) that hold cover (12) in the control panel.
Move shifter lever (11) out of the park position.
Remove shift control assembly (18) from the control panel.
Pressurized air can cause personal injury. The air supply lines are pressurized to 830 kPa (120 psi).Purge the air from the system before performing any maintenance to the air system.
Illustration 4 g00636990
Remove bolt (14) and disconnect electrical socket (16) from shift control box (18) .
Disconnect the fittings on air hoses (15) and (17) from air control valve (13) .
Remove shift control box (18) from the control panel.
Illustration 5 g00636991
Note: Mark the position of elbows (19) and (22) for installation purposes.
Remove two elbows (22) and elbow (19) from the air control valve (20) .
Loosen jam nut (21) and remove valve assembly (20) from shift control box (18) .