GUARD AS-ALTERNATOR 5016696 - Caterpillar

Illustration 1 g01413664
(1) Select "Monitoring System".
(2) Check the RPM settings. For this example, 75 percent of the programmed 2200 rpm is 1650 rpm. When you perform the overspeed verification, monitor the engine rpm in order to verify that the engine shuts down upon achieving 75 percent of the programmed value.Performing the Procedure with the Junction Box
Illustration 2 g01413665
(3) Overspeed switch To set the overspeed verify feature, toggle the momentary switch for approximately one second. This will cause the overspeed shutdown to occur at 75 percent of the programmed overspeed setting.Note: The function of the toggle switch can be configured in Cat ET to function as an overspeed verify switch or as a torque limit switch. The factory default is the overspeed verify switch.Start the engine and monitor the engine rpm during acceleration in order to determine whether the engine shuts down at 75 percent of the programmed setting.Performing the Procedure with Cat ET
Illustration 3 g01413666
(4) Double click on "Engine Overspeed Test"
(5) Select "Override Parameters". From the "Diagnostics" drop-down menu, select "Diagnostic Tests". Then select "Override Parameters". Then select the "Engine Overspeed Test".
Illustration 4 g01413667
(6) Select "ON". Select "ON" and click "OK". Keep the screen for override parameters active. If you leave the screen for override parameters the parameter will automatically default back to the normal mode and the engine will not shut down at 75 percent of the programmed setting.Start the engine and monitor the engine rpm during acceleration in order to determine whether the engine shuts down at 75 percent of the programmed setting.