GUARD AS 5233090 - Caterpillar

Removal Procedure
Illustration 1 g02520941
Slide locking tab (2) (not shown) into the unlocked position. Disconnect harness assembly (1) from harness assembly (4) for the temperature sensor.
Cut cable straps (5) and cable strap (3).
Remove temperature sensor (6) from tube assembly (7) for the NRS Induction mixer. Installation Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A - Bostik Pure Nickel
Anti-Seize Compound 1
Ensure that the wiring harness assembly is correctly routed and the cable straps are not over tightened. Over tightening of the cable straps will damage the wiring harness and the convoluting.
Ensure that all components are clean and free from wear and damage. If necessary, replace any components that are worn or damaged.
Illustration 2 g02520941
Lightly lubricate the thread of temperature sensor (6) with Tooling (A). Install temperature sensor (6) to tube assembly (7) for the NRS Induction mixer.
Torque temperature sensors (6) to a torque of 24 N m (212lb in).
Connect harness assembly (1) to harness assembly (4) for the temperature sensor. Slide locking tab (2) (not shown) into the locked position.
Install new cable straps (5) and a new cable strap (3) to harness assembly (4). Note: Ensure that cable straps meet the Original Equipment Manufactures (OEM) specification.