GUARD ASSEM. (R.H.) 5G1802 - Caterpillar

Illustration 1 g03827818
Typical lifting eye locations on a C280-16 Marine Engine.
Use a hoist to remove heavy components. Some removals require lifting fixtures to obtain proper balance and safety.
Illustration 2 g00902989
Never bend the eyebolts and the brackets. Only load the eyebolts and the brackets under tension. Remember that the capacity of an eyebolt is less as the angle between the supporting members and the object becomes less than 90 degrees.When it is necessary to remove a component at an angle, only use a link bracket that is properly rated for the weight.
To lift the engine ONLY, attach anchor shackles to the lifting eyes that are on the engine. The lifting eyes are designed and installed for the specific engine arrangement. Alterations to the lifting eyes and/or the engine make the lifting eyes and the lifting fixtures obsolete. If alterations are made, ensure that proper lifting devices are provided. Consult your Cat dealer for information regarding fixtures for proper engine lifting. Use an adjustable lifting beam to lift the entire engine. All supporting members (chains and cables) should be parallel to each other. The chains and cables should be perpendicular to the top of the object that is being lifted. Follow the instructions that are on the engine lifting warning labels:
Illustration 3 g01231066
Use proper spreader bar, as shown.
Attach two proper rated cables to spreader bar from engine lift shackles.
Illustration 4 g01231042The "Do Not Lift" films are applied to various locations on the product. DO NOT use these locations to lift the product.Aftertreatment Component Lifting
Improper lift rigging can allow unit to tumble causing injury and damage.
Refer to the Application and Installation Guide for additional information on lifting aftertreatment components.
Table 1
Weight of Reactor Housing (CEM)
C280-16 CEM 1741 kg (3838 lb) SCR Reactor Housing (CEM)
Note: Remove catalysts prior to lifting the CEM.
Illustration 5 g03501569
SCR reactor housing lifting eyes
Attach appropriately lifting equipment to the lifting eyes at each corner of the SCR reactor housing. Ensure that lifting equipment is clear of all sensors and fittings prior to lifting. Do not use reactor housing mounting feet to lift the SCR reactor housing.Lifting the Dosing Cabinet
Illustration 6 g03828699
Typical location of the dosing cabinet lifting slots.
Insert the appropriate lifting straps through the lifting slots, as indicated, in the base of the dosing cabinet.
Table 2
Dosing Cabinet Dimensions
Length 1010 mm (39.8 inch)
Width 553 mm (21.7 inch)
Height 634 mm (25 inch)
Weight without DEF 140 kg (309 lb)