GUARD AS-TRACK GUIDE 6P7610 - Caterpillar

1. Put identification on all of the electrical wires as to their correct location for installation purposes.2. Loosen three bolts (2), and remove three bolts (1). Remove cover (3) from the sheet assembly.3. Remove the nuts, and disconnect the wires from switch (main relay) (4).4. Remove the two bolts and switch (main relay) (4). 5. Remove the nuts, and disconnect the wires from switch (start relay) (5).6. Remove the two nuts and switch (start relay) (5).7. Remove the nut and diagnostic connector (receptacle) (6).8. Remove the nuts, and disconnect the wires from circuit breaker (60 amp) (9). Remove the two screws and circuit breaker (9).9. Remove the nuts, and disconnect the wires from circuit breaker (10 amp) (8). Remove the two screws and circuit breaker (8).10. Remove the nuts, and disconnect the wires from circuit breaker (15 amp) (7). Remove the two screws and circuit breaker (7). The following steps are for the removal of the circuit breakers and switches for the 926 Wheel Loaders.11. Disconnect the wire from the right rear floodlight. Remove the nut and clip that hold the wiring harness to the floodlight bracket, and pull the wiring harness through the rubber grommet in the right sheet assembly.12. Remove the six bolts, and remove the right sheet assembly and engine access door as a unit to gain access to the circuit breakers and switches. 13. Put identification marks on all of the electrical wires as to their correct location for installation purposes.14. Repeat steps 4 through 10 to remove the circuit breakers and switches from 926 Wheel Loaders.Install Circuit Breakers And Switches
The following steps are for the installation of the circuit breakers and switches for 926 Wheel Loaders. 1. Put circuit breaker (15 amp) (3) in position, and install the two screws that hold it in place.2. Put the wires in position on circuit breaker (3), and install the nuts that hold them in place.3. Put circuit breaker (10 amp) (4) in position, and install the two screws that hold it in place.4. Put the wires in position on circuit breaker (4), and install the nuts that hold them in place.5. Put circuit breaker (60 amp) (5) in position, and install the two screws that hold it in place.6. Put the wires in position on circuit breaker (60 amp) (5), and install the nuts that hold them in place.7. Put diagnostic connector (receptacle) (2) in position, and install the nut that holds it in place.8. Put switch (start relay) (1) in position, and install the bolts and nuts that hold it in place.9. Put the wires in position on switch (1), and install two nuts that hold them in place.10. Put switch (main relay) (6) in position, and install the two