GUARD ASSEM. 7P7922 - Caterpillar

Illustration 2 g03324690
Locations of the connectors at the ECM that are for the 16 cylinder engines (typical front engine view) (1) Connector for the right-hand rail (2) J1/P1 ECM connectors (3) J2/P2 ECM connector (4) Engine interface connector at the control box (4) Connector for the front harness
Illustration 3 g01323936
Terminal locations at the P1 ECM connector for the electrical power supply (P1-48) +Battery (P1-52) +Battery (P1-53) +Battery (P1-55) +Battery (P1-57) +Battery (P1-61) −Battery (P1-63) −Battery (P1-65) −Battery (P1-67) −Battery (P1-69) −Battery (P1-70) Keyswitch circuit
Illustration 4 g01324119
Terminal locations at the connector for the fuel control valve that are for the electrical power supply (Terminal 8) Keyswitch circuit
Table 2
Troubleshooting Test Steps    Values    Results    
1. Inspect the Electrical Connectors and the Wiring
A. Turn the battery disconnect switch to the OFF position.
B. Thoroughly inspect connectors (1) through (2) and (3) through (4). Inspect the wiring for the crossover harness that is in the control box for abrasion. Also check the condition of the circuit breakers in the low current and high current power distribution panels. Ensure that the breakers are in good repair and are not tripped. Refer to Troubleshooting, "Electrical Connectors - Inspect" for the proper procedure for inspecting system wiring.
C. Perform a
45 N (10 lb) pull test on each of the wires in the ECM connector that are associated with the circuit.
D. Check the ECM connector (allen head screw) for the proper torque. Refer to Troubleshooting, "Electrical Connectors - Inspect" for details.
E. Check the harness and the wiring for abrasion and for pinch points.
F. Check each of the fuses at the low current power distribution panel that are associated with the circuit. At the high current power distribution panel, ensure that the main circuit breaker has not been thrown.
Note: Replace any fuses that are blown. If necessary, reset the main circuit breaker.
   
Connectors    
Results: The harness and wiring are OK.
Proceed to Test Step 2
Results: There is a problem in the connectors and/or wiring.
Repair the connectors or wiring and/or replace the connectors or wiring. Ensure that all of the seals are properly in place and ensure that the connectors are coupled.
Verify that the repair eliminates the problem.
   
2. Check the Voltage at the Battery Post
A.