GUARD AS-FAN 9Y2770 - Caterpillar



9Y2770 GUARD AS-FAN Caterpillar parts D7H, D8N
Rating:
43
Alternative (cross code) number:
CA9Y2770
9Y-2770
9Y2770
Caterpillar 9Y2770 GUARD AS-FAN
Weight: 10 pounds 4 kg.

Buy GUARD AS-FAN 9Y2770 Caterpillar genuine, new aftermarket tractor parts with delivery
TRACK-TYPE TRACTOR,

Compatible equipment models: 9Y2770:

TRACK-TYPE TRACTOR  D7H   D8N   Caterpillar
Number on catalog scheme: 5
  For full view, you need register

Caterpillar parts catalog:

Caterpillar parts catalog
D8N TRACTOR 9TC00001-UP (MACHINE) POWERED BY 3406 ENGINE
D8N TRACTOR 1XJ00001-UP (MACHINE) POWERED BY 3406 ENGINE
D8N TRACTOR / POWER SHIFT / 5TJ00001-UP (MACHINE) POWERED BY 3406 ENGINE
D7H & D7H LGP TRACTORS / POWER SHIFT / /DIFFERENTIAL STEERIN/ 4FG00001-03999 (MACHINE) POWERED BY 3306 ENGINE
D7H & D7H LGP TRACTORS /DIFFERENTIAL STEERIN/ 4FG04000-UP (MACHINE) POWERED BY 3306 ENGINE
D7H & D7H LGP SERIES II TRACTORS / POWERSHIFT / 79Z04000-UP (MACHINE) POWERED BY 3306 ENGINE
D7H & D7H LGP TRACTORS / POWER SHIFT / 79Z00001-03999 (MACHINE) POWERED BY 3306 ENGINE
D7H & D7H LGP TRACTORS / POWER SHIFT / /DIFFERENTIAL STEERIN/ 4FG00001-03999 (MACHINE) POWERED BY 3306 ENGINE
D7H & D7H LGP TRACTORS /DIFFERENTIAL STEERIN/ 4FG04000-UP (MACHINE) POWERED BY 3306 ENGINE
D7H & D7H LGP SERIES II TRACTORS / POWERSHIFT / 79Z04000-UP (MACHINE) POWERED BY 3306 ENGINE
D7H & D7H LGP SERIES II TRACTORS / POWERSHIFT / 4AB04000-UP (MACHINE) POWERED BY 3306 ENGINE
D7H & D7H LGP SERIES II TRACTORS / DIRECT DRIVE / 2SB04000-UP (MACHINE) POWERED BY 3306 ENGINE
D7H & D7H LGP SERIES II TRACTORS / POWERSHIFT / 2RG04000-UP (MACHINE) POWERED BY 3306 ENGINE
D7H & D7H LGP SERIES II TRACTOR / POWERSHIFT / 2RG05500-UP (MACHINE) POWERED BY 3306 ENGINE
D8N Track-Type Tractor 7TK00001-UP (MACHINE)


Information:


Illustration 1 g00544436
Schematic for the lamp (action)This diagnostic code is recorded when the main display module reads the voltage of the circuit for the action lamp as above normal. The action lamp is ON CONTINUOUSLY as a result of this diagnostic code. The schematic that is shown above represents a typical installation of the component. Verify the connector contact and wire numbers by using the Electrical System Schematic for the machine that is being serviced. Test Step 1. CHECK THE LAMP CIRCUIT.
Turn the disconnect switch and the key start switch to the OFF position.
Disconnect the machine harness from the main display module.
Turn the disconnect switch to the ON position.
Observe the action lamp.
Turn the key start switch to the ON position.Expected Result:The action lamp is ON.Results:
OK - The action lamp is ON. The harness circuit 411-PK is shorted to the +battery. Repair: Repair the harness or replace the harness.STOP
NOT OK - The action lamp is OFF. The module has failed.Repair: It is unlikely that the main display module has failed. Exit this procedure and perform this procedure again. Also, recheck if the diagnostic code indicator is illuminated for this diagnostic code. If the cause of the diagnostic code is not found, replace the main display module. See Testing and Adjusting, "Module - Replace".STOP

Parts guard Caterpillar catalog:

1110419 GUARD AS
572R, D7H, D7R
1110416 GUARD AS
572R, D7H, D7R
4Y8435 GUARD
D7H, D7R II, D7R XR
8Y0388 GUARD AS
D4H, D4HTSK II, D4HTSK III
3W1357 GUARD AS
D6H, D6H XR, D6R, D6R II, D6T