GUIDE 1958154 - Caterpillar

Illustration 3 g01423926
Disconnect hose assembly (5). Disconnect hose (6) .
Illustration 4 g01423931
Disconnect hose assembly (7).
Remove bolts (8). Repeat this step for the opposite side. Remove hydraulic oil cooler assembly (9) .
Illustration 5 g01423939
Remove bracket (10). Attach a suitable lifting device and Tooling (B) to support assembly (11). The weight of support assembly (11) is approximately 27 kg (60 lb). Remove bolts (12). Remove support assembly (11) .
Illustration 6 g01423945
Illustration 7 g01423947
Attach Tooling (C) and a suitable lifting device to aftercooler (13). Remove bolts (14) and remove aftercooler (13) .Installation Procedure
Table 2
Required Tools    
Tool     Part Number     Part Description     Qty    
A     311-1362     Vacuum Cap     1    
B     140-7742     Sleeve     1    
C     138-7575     Link Bracket        Note: Cleanliness is an important factor. Before you begin the installation procedure, the exterior of the components should be thoroughly cleaned. This will help to prevent dirt from entering the internal mechanism.Note: Check the O-ring seals, the gaskets, and the seals for wear or for damage. Replace the components, if necessary.
Illustration 8 g01423945
Illustration 9 g01423947
Attach Tooling (C) and a suitable lifting device to aftercooler (13). Position aftercooler (13) and install bolts (14) .
Illustration 10 g01423939
Attach a suitable lifting device and Tooling (B) to support assembly (11). The weight of support assembly (11) is approximately 27 kg (60 lb). Position support assembly (11) and install bolts (12). Install bracket (10) .
Illustration 11 g01423931
Position hydraulic oil cooler assembly (9).
Install bolts (8). Repeat this step for the opposite side.
Connect hose assembly (7) .
Illustration 12 g01423926
Connect hose assembly (5). Connect hose (6) .
Illustration 13 g01374019
Remove Tooling (A) from the hydraulic tank.
Illustration 14 g01423913
Install bracket (1). Connect hose (2) .
Position refrigerant condenser (3) .
Install bolts (4). Repeat this step for the opposite side. End By: Install the engine enclosure. Refer to Disassembly and Assembly, "Engine Enclosure - Install".