GUIDE 8P2424 - Caterpillar

Assembly Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A 1P-0520 Driver Group 1
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Illustration 1 g06183041
Align the oil hole in sleeve bearing (10) and the oil hole in pump adapter assembly (4). Use Tooling (A) and a suitable press to install sleeve bearing (10) into pump adapter assembly (4).Note: The sleeve bearing must not project above the pump adapter assembly.
Install O-ring seal (12) and O-ring seal (11) on pump adapter assembly (4).
Apply clean engine oil to sleeve bearing (10).
Illustration 2 g06183012
Position accessory drive gear (9) on pump drive shaft (7). Install bolts (8).
If necessary, install socket setscrew (13) in the end of pump drive shaft and tighten to a torque of 6 1 N m (53 9 lb in).
Illustration 3 g06183010
Install pump adapter assembly (4) onto pump drive shaft (7).
Install thrust washer (6) and bolts (5).
Illustration 4 g06183005
Align the oil hole in sleeve bearing (1) and the oil hole in pump adapter assembly (2). Use Tooling (A) and a suitable press to install sleeve bearing (1) into pump adapter assembly (2).
Install O-ring seal (3) on the pump adapter assembly.End By:
Install the accessory drive for the engine oil pump and the water pump. Refer to Disassembly and Assembly, "Accessory Drive (Front) - Install".