GUIDE-INNER 9T7773 - Caterpillar

Removal Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A 138-7573 Link Bracket 2
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat products.Dispose of all fluids according to local regulations and mandates.
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Drain the coolant from the cooling system into a suitable container for storage or for disposal. Refer to Operation and Maintenance Manual, "Cooling System Coolant - Change".
Illustration 1 g01949540
Remove bolts (3) and strap (4).
Remove bolt (7) and loosen clamps (1). Remove air pipe (2). Remove the O-ring seals from air pipe (2).
Remove bolts (6), air inlet elbow (5), and the O-ring seal.
Repeat for the other side of the aftercooler.
Illustration 2 g01949543
Remove bolts (8) and disconnect elbow (9). Remove the O-ring seal.
Disconnect hose assembly (12). Remove bolts (10) and disconnect elbow (11). Remove the O-ring seal.
Remove bolts (13) and disconnect the flange. Remove the O-ring seals.
Remove bolts (14) and disconnect the flange. Remove the O-ring seals.