GUIDE-VALVE 9Y8848 - Caterpillar

Installation Procedure
Table 1
Required Tools    
Tool     Part Number     Part Description     Qty    
A     7M-7260     Liquid Gasket     1    
B     -     3/8 - 16 NC Guide Bolts     4    
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Illustration 1 g00604494
Typical Example
Inspect O-ring seal (4) for the connector to the oil pump. If the seal is cut, scratched, or cracked, obtain a new seal for assembly. Lubricate the bore for the seal with clean engine oil. Install the seal.
Make sure that the surface for gasket (3) is clean. Apply Tooling (A) to gasket (3) . Install Tooling (B) in the oil pan. Place the gasket into position.
Improper lift rigging can allow unit to tumble causing injury and damage.
Note: If improper equipment is used to lift the engine, injury and damage can occur. Use cables or chains that are properly rated for the weight. Use a spreader bar and attach the cables or chains according to the information that is on the lifting film for the engine.
Illustration 2 g00604420
Typical Example
Attach a suitable lifting device to the engine lifting eyes.
The weight of the 3508 Engine is approximately 4445 kg (9800 lb). The weight of the oil pan is approximately 240 kg (530 lb).
The weight of the 3512 Engine is approximately 5900 kg (13,000 lb). The weight of the oil pan is approximately 295 kg (650 lb).
The weight of the 3516 Engine is approximately 7711 kg (17,000 lb). The weight of the oil pan is approximately 409 kg (900 lb).
Lift the engine. Place the engine onto the oil pan or place the oil pan in position under the engine. Remove Tooling (B) from the oil pan.
Illustration 3 g00604419
Typical Example
Illustration 4 g00604418
Typical Example
Install bolts (2) that hold the engine and the oil pan together.
Illustration 5 g00604417
Typical Example
Install bolts (1) that hold the connector for the oil pump to the oil pan.
Fill the engine crankcase with oil. Refer to the Operation and Maintenance Manual, "Capacities (Refill)" for the oil capacity.