HANDLE-KEY 1383320 - Caterpillar

Table 1
Required Tools
Tool Part Number Part Description Qty
A 350-7768 Electric Hydraulic Pump Gp (115V) 1
350-7769 Electric Hydraulic Pump Gp (230V) 1
141-1785 Receiving Sleeve As 1
6V-3175 Double Acting Cylinder 1
137-8460 Puller Stud 1
9X-8399 Washer 1
9U-5346 Nut 1
140-7742 Sleevet 2
B 350-7768 Electric Hydraulic Pump Gp (115V) 1
350-7769 Electric Hydraulic Pump Gp (230V) 1
141-1785 Receiving Sleeve As 1
9U-6811 Puller Stud 1
6V-0113 Double Acting Cylinder 1
101-0007 Hard Washer 1
9U-6809 Nut 1
When you are using hydraulic cylinders and puller studs, always ensure that the rated capacity of the puller stud meets or exceeds the rated capacity of the hydraulic cylinder. If the puller stud does not meet or exceed the rated capacity of the hydraulic cylinder, a sudden failure of the puller stud could occur. The sudden failure of the puller stud could result in personal injury or death.
Do not use threaded rods that have not been hardened as tooling with hydraulic cylinders. The maximum rated tonnage should be stamped on one end of the puller studs. Do not use threaded rods that have not been stamped with the rated tonnage.
Illustration 1 g06249658
Illustration 2 g06249989
Illustration 3 g06250039
Combined weight of Tooling and pin assembly are 176 kg (375 lb).
Note: Reposition the suitable lifting device as pin assembly is removed.
Illustration 4 g06250121
Illustration 5 g06250132
Combined weight of Tooling and pin assembly are 210 kg (465 lb).
Note: Reposition the suitable lifting device as pin assembly is removed.
Illustration 6 g06250138Install Procedure
Install the bucket in the reverse order of removal.
Illustration 7 g06250222
Move the bucket to the side until the bucket contacts the stick. Measure the clearance between the bucket and the stick at the flange. Record this dimension as Dimension (X). Add or remove shims until Dimension (X) is 0.5 to 1.0 mm (0.02 to 0.04 inch).