HANDLE GP-MODULAR 2086097 - Caterpillar

Assembly Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A — Loctite 242 1
Illustration 1 g06025876
Apply Tooling (A) to the two bolts. Install the two bolts and cap (16) to shaft (7).
Install key (15) to shaft (7).
Illustration 2 g06025850
Install sprocket (14) to shaft (7).
Install two washers (13) to shaft (7).
Apply Tooling (A) to the two set screws. Tighten the two set screws.
Illustration 3 g06025835
Install bearing (12).
Apply Tooling (A) to the two set screws. Tighten the two set screws.
Illustration 4 g06025820
Install spacer assembly (11) to shaft (7). Tighten the set screw.
Illustration 5 g06025813
Install key (10) to shaft (7).
Illustration 6 g06025806
Illustration 7 g06025898
Install sprocket (9) and two washers (8) to shaft (7).
Measure the distance from the outside of the right sprocket to the outside of the left sprocket. This distance is dimension (X). Dimension (X) should measure 630 mm (24.8 inch).
Apply Tooling (A) to the two set screws. Tighten the two set screws.
Illustration 8 g06025796
Install four bolts (6), the six washers, and bearing assembly (5).
Illustration 9 g06025774
Install shaft assembly (3) to frame support (4).
Illustration 10 g06025760
Tighten two set screws (2.).
Illustration 11 g06025755
Install two bolts (1) and the two washers.End By:
Install the feeder drive shaft group. Refer to Disassembly and Assembly, "Feeder Drive Shaft Group - Remove".