HANDLE 3W1473 - Caterpillar

Illustration 1 g00103219
Never bend the eyebolts and the brackets. Only load the eyebolts and the brackets under tension. Remember that the capacity of an eyebolt is less as the angle between the supporting members and the object becomes less than 90 degrees.When it is necessary to remove a component at an angle, only use a link bracket that is properly rated for the weight.
Center-pull Style Hoist Ring SupplierColumbus McKinnon Corporation
140 John James Audubon Parkway
Amherst, NY 14228-1197
Table 1
Center-pull Style Hoist Ring
Part Number Rated Load (kg) A B C
4-34614 1900 25 mm (0.984 inch) 48 mm (1.89 inch) M16 x 2.0
Illustration 2 g01949278
Center-pull style hoist ring
(A) Maximum Allowable Thread Depth on Hoist Ring is 27 mm (1.063 inch)
(B) 48 mm (1.89 inch) (As large as possible or it will coin case with lift angles)
(C) M16 x 2.0 Eyebolts are not recommended for lifting this transmission. Suitable center-pull style hoist rings are recommended only for lifting angles of 60° and greater from horizontal. Lift angles that are less than 60° from horizontal are not acceptable.
Illustration 3 g01879554
Typical example of a CX31–P600 Petroleum Transmission (shown without integral pump drives and without drop box).
Lift angles that are less than 60° from horizontal are not acceptable.
Use a hoist to remove heavy components. Use an adjustable lifting beam to lift the transmis`sion. All supporting members (chains and cables) should be parallel to each other. The chains and cables should be