HANDLE A. 9S3095 - Caterpillar

Illustration 9 g06142534
Close up of area H.
Next, weld the ear plates on both sides to the fork frame using an 8 mm filet weld as shown.Note: Ear plates can be modified as needed to level the bucket and line up with the pin holes.Note: Do not weld the ends of the plates.
Allow welded area to cool. Prepare the welded area for paint application.
Apply the rust prevention coat and the finish coat to the work area that has been completed. Use Caterpillar approved paint.
Illustration 10 g06142557
Assembled view of the 510-9841 Slip-On Material Bucket.
Slide forks into bucket and secure to the fork frame with pins.522-4941 Slip-On Material Bucket
Table 4
522-4941 Slip-On Material Bucket (- 01)
Item Qty Part No. Part Name
(1) 2 3B-4626 Cotter Pin
(2) 2 4F-0255 Pin
(3) 1 137-4234 Identification Plate
(4) 4 390-6869 Ear Plate
(5) 1 522-4942 MH Bucket As
(6) 2 1U-0761 End Edge
(7) 2 1U-0762 Cutting Edge
(8) 2 2J-8937 Pin
(9) 1 312-5694 Setscrew
(10) 12 3K-9770 Full Nut
(11) 12 5P-8823 Bolt
Illustration 11 g06186551
Slide forks into the 522-4941 Slip-On Material Bucket with parts in area (J) attached.
(1) 3B-4626 Cotter Pin
(2) 4F-0255 Pin
(4) 390-6869 Ear Plates
(8) 2J-8937 Pin
Attach the parts listed in area (J) to the rear of the bucket. Then insert the forks as shown.Note: Be sure to slightly pick up the bucket and tilt back to ensure that there are no gaps between the bucket and forks.
Illustration 12 g06186597
Rear center view of the 522-4941 Slip-On Material Bucket
(K) 48 2 mm (1.8 0.1 inch)
(L) 96 4 mm (3.8 0.2 inch)
(M) 407 mm (16 inch)
(N) 292 mm (11 inch)
Center the bucket on the forks and tack weld the four Ear Plates in place on both sides.Note: Ear plates can be modified as needed to level the bucket and line up with the pin holes.Note: Do not weld the ends of the plates.
Set the bucket on the ground, remove the pins, and slide the forks out.
Illustration 13 g06186618
Close up of area P.
Next, weld the four ear plates on both sides to the fork frame using an 8 mm filet weld as shown.Note: Ear plates can be modified as needed to level the bucket and line up with the pin holes.Note: Do not weld the ends of the plates.
Allow welded area to cool. Prepare the welded area for paint application.
Apply the rust prevention coat and the finish coat to the work area that has been completed. Use Caterpillar approved paint.
Illustration 14 g06186629
Assembled view of the 522-4941 Slip-On Material Bucket.
Slide forks into bucket and secure to the fork frame with pins.