AVSPARE.COM
parts catalog

HARNESS AS 0551736 - Caterpillar


0551736 HARNESS AS Caterpillar parts
Rating:
16
Alternative (cross code) number:
CA0551736
055-1736
0551736
Caterpillar 0551736 HARNESS AS
Weight: 1 pounds 0 kg.

Buy HARNESS AS 0551736 Caterpillar genuine, new aftermarket tractor parts with delivery

  For full view, you need register

Information:

Procedure To Install New Front Suspension Cylinder Assemblies And Relief Valve Assembly
1. Park the machine on hard level ground. Raise the tractor and support it with suitable stands at the front and rear of the main frame.
Release of hydraulic oil under pressure can cause injury or death to persons on or near the machine. Be sure all hydraulic pressure is released from the system prior to loosening any fittings, hoses or other components in the hydraulic system.
2. Remove the front wheels.3. Disconnect the remote grease lines from the pivot pins of the top and bottom cylinders.4. Use suitable lifting equipment and blocks to support the front axles. Disconnect the hydraulic lines from the front suspension cylinder assemblies. Plug all hose ends to keep dirt and foreign material out of the hydraulic system. In the following steps, the installation procedure should only be performed on one side of the machine at a time. This will prevent movement of the axle assembly.5. Remove the former cylinder assembly from one side of the machine. Keep the pivot pins, seal faces, washers, lockwashers and bolts. Discard the O-ring seals.6. Inspect all components for wear or damage. Replace any parts if necessary.7. Install the new 6U4161 Suspension Cylinder Assembly in the reverse order of removal of the former cylinder assembly. Use new O-ring seals when installing the pivot pins.8. Remove the former cylinder assembly from the other side of the machine. Install the new suspension cylinder assembly. Repeat Steps 5 through 7.9. Remove the former 2U1561 Relief Valve Assembly from the suspension control valve. See the illustrations for the location of the valve assembly.10. Install the new 2U0962 Relief Valve Assembly.11. Assemble all items previously removed. Remove all stands and blocks from under the machine.12. Lubricate the cylinder pivot pins before operating the machine. Check the level of the hydraulic oil.
Illustration 1. Location of relief valve assembly on all machines except those with suspended single axle trailers.
Illustration 2. Location of relief valve assembly on all machines with suspended single axle trailers.


Parts harness Caterpillar catalog:

Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.