HARNESS AS-SENSOR 1007424 - Caterpillar

1007424 HARNESS AS-SENSOR Caterpillar parts 938F, 992C, 992D

Price: query
Add in request price Go to cart

Rating:

Alternative (cross code) number:
CA1007424
100-7424
1007424

Weight: 1 pounds 0 kg.

Buy HARNESS AS-SENSOR 1007424 Caterpillar genuine, new aftermarket tractor parts with delivery
WHEEL LOADER,

Compare Prices: .

As an associate, we earn commssions on qualifying purchases through the links below

Granit 50702259 5089705 Multifunction Switch 1007424

$126.99

18 Dec 2024
0.5731[0.26] Pounds
US: Over The Hill T

Granit 50702259 5089705 Multifunction Switch 1007424
Generic Multifunction switch || 50702259

Granit 50702259 5089705 Multifunction Switch Compatible with New Holland 1007424

$126.99

15 Dec 2024
0.5731[0.26] Pounds
US: Over The Hill T

Granit 50702259 5089705 Multifunction Switch Compatible with New Holland 1007424
Granit Compatible with New Holland || Multifunction switch || 50702259

Granit 50702259 5089705 Multifunction Switch Compatible with Case IH 1007424

$126.99

15 Dec 2024
0.5731[0.26] Pounds
US: Over The Hill T

Granit 50702259 5089705 Multifunction Switch Compatible with Case IH 1007424
Generic Compatible with Case IH || Multifunction switch || 50702259

Number on catalog scheme: 33

Caterpillar 1007424 Parts scheme HARNESS AS-SENSOR

For full view, you need register

Compatible equipment models: 1007424:

WHEEL LOADER 938F 992C 992D Caterpillar

Information:

Table 1
J2-67 J2-68 J1-70
0.5V to 4.5V 0.5V to 4.5V 0V ReferenceRefer to Table 1 for the expected results.Expected Result:The voltage of the wires for the Data Link is correct.Results:
YES - The voltage of the wires for the Data Link is correct. Proceed to Test Step 5.
NO - A voltage is measured at J1-70. A voltage on J1-70 means that there is a short to the battery.Repair: Repair the machine harness or replace the machine harness. Proceed to Test Step 7.
NO - The voltage at J2-67 or J2-68 is greater than 4.5 V.Repair: Repair the machine harness or replace the harness. Proceed to Test Step 7.
NO - The voltage at J2-67 or J2-68 is less than 0.5 V. Proceed to Test Step 3.Test Step 3. CHECK FOR A SHORT TO GROUND
Turn the disconnect switch and the key start switch to the OFF position.
Disconnect the J2 harness connector from the Machine ECM. Disconnect the harness connector from keypad 2.
Measure the resistance of wire (F711-YL) to an unpainted frame ground. Measure the resistance of wire (F712-GN) to an unpainted frame ground.Expected Result:The resistance measurement is greater than 5 ohms.Results:
YES - The resistance measurement is greater than 5 ohms. Proceed to Test Step 4.
NO - The resistance measurement is less than 5 ohms. The wire with the low resistance measurement is shorted to ground.Repair: Repair the machine harness or replace the machine harness. Proceed to Test Step 7.Test Step 4. CHECK FOR A SHORT IN THE WIRES FOR THE DATA LINK
The disconnect switch and the key start switch remain