HARNESS AS-CAB 1018162 - Caterpillar

Improper operation of an access platform could result in injury or death.Operators must carry out their duties properly and follow all instructions and guidelines given for the machine and access platform.
Note: Clean the object detection sensors before inspection and adjustment.The Object Detection System radar is mounted on an adjustable mounting bracket. If adjusted too low, the radar may falsely detect an object. If adjusted too high, the system may not detect smaller objects near the ground. The following is the recommended adjustment procedure for the radar.
Move the machine to a smooth, horizontal location that is away from operating machines and away from personal.
Place the transmission in the NEUTRAL position.
Engage the parking brake.
Lower the lift arms to the ground.
Shut off the machine.
Check tire pressures and adjust if necessary to appropriate setting for machine operation.
Illustration 1 g06009595
Type 1 Sensor - Rear View of Machine
(A) Cover
Remove cover (A).
Illustration 2 g06009601
View of Bracket
(B) Adjustment Setting Bolts
(C) Hinge Bolts
Remove adjustment setting bolts (B) and loosen hinge bolts (C).
Illustration 3 g06010027
Use a level to plumb the sensor mounting bracket.
Illustration 4 g06010021
Adjust the bracket angle up from plumb rotating to next available hole.Note: If an angle finder is available, target the adjustment to be +3° 1.75° from level for a Type 1 Sensor and +1° 1.75° from level for a Type 2 Sensor.
Tighten adjustment setting bolts (B) and hinge bolts (C) to 3.7 0.8 N m (33 7 lb in)
Reinstall cover. Torque bolts to 15 3 N m (11 2 lb ft)