HARNESS AS-FRONT 1059769 - Caterpillar

Upgrading to the Latest Version v2.0.2
Table 1
Software Part Numbers    
Quantity    Part Number    Description    
1     433-3539     Software Group (HIM, HD)    
1     433-3541     Software Group (HIM, HU)    This Service Magazine article contains information about the current release for the health interface module version 2.0.2. This release replaces previous version 2.0.1.
Illustration 1 g03331039
(1) ECM serial numberNote: Ensure that the correct software part number is used for installation by reviewing the last two characters of the ECM serial number. Refer to Table 1. Refer to Illustration 1 for an example of an ECM serial number.New Features
The following new features are available:
Support for Cat® Fleet on-board v3.1Note: Customers that are installing or upgrading to Fleet on-board v3.1 must use health interface module version 2.0.2.
Support of Trimble Medium Precision MS352 CAN-based satellite receiver.
The CAN-based satellite receiver firmware version number is now shown on the device status webpage as the "GPS Source" field.
Addition of a graphical user interface web page in order to support configuration of the Trimble CAN-based satellite receivers for use with Fleet on-board v3.1.
Ability to configure channel polling for 777F trucks.Note: The VIMS parameters that the health interface module uses for channel polling are configured with a binary configuration file. This new binary configuration file is available from SIS.
Full support for use with Cat Electronic Technician (Cat ET).When using Cat ET v2011C or later, the ECM is now properly detected. The "Health Interface Module" now displays in the list of available ECM(s). Previously, "Unknown" was displayed for the health interface module in earlier versions. Health interface module information is now available in the ECM Summary page.
The "Correction Availability" value (field 14) for all record types in the report file (csv) is now populated with the correct value.
The "Fuel Used" value (field 30) for the "VimsTpmsCycle2" record in the report file (csv) is now populated with the correct value.
Ability to configure the GPS correction port (UDP) with values between 32767 and 65535 is now supported. Previously, any value of 32767 and up was automatically reset to the default value of 3784.When using a Sierra Wireless Airlink Raven X cell modem, the health interface module cannot obtain a valid DHCP address if all of the following conditions occur:
The cell modem is configured to use "Host Public Mode (Value 0)"
The health interface module is configured to use DHCP
The health interface module is powered up at the same time or before the cell modem is powered upVIMS version 10.52 or later is required on Large Mining Trucks and VIMS version 11.0.6 is required on 777F for improved stability with the CAN communications interface.Note: Shutting down the machine and then powering back-up the machine will re-establish communication.Note: Upgrading the VIMS ABL firmware to a newer version will resolve this issue. Use SIS Web in order to obtain the latest version of VIMS firmware.Limitations
NMEA satellite receivers that broadcast NMEA sentences at a frequency greater than 1 Hz are not supported.Note: This condition applies