HARNESS AS 1160227 - Caterpillar

Table 6
Terminal Locations in the Plug    
Wire Color    Location in Plug    
Shield     C    
Yellow     A    
Green     B    
Position the 125-7876 Heat Shrink Tubing so that 10 mm (0.4 inch) of the plug is covered and the rest of the heat shrink tubing is over the cable. Apply heat until a complete seal is formed around both the plug and the cable. Be careful to avoid skin contact with any hot glue that may seep from the heat shrink tubing. Perform this process on both ends of the cable.
Plug one end of the new cable into one of the openings in the existing tee. Plug the other end of the new cable into the single end of a 133-0970 Receptacle As (Tee) for the additional module.
If you are installing additional modules, repeat Step 2 for each module.
Illustration 5 g00935709
Connecting a J1939 module
Connect a receiving module to the tee.
Plug a 165-0200 Cable As into the 133-0970 Receptacle As (Tee).
Cut a 50 mm (2 inch) piece of 125-7876 Heat Shrink Tubing. Slide the heat shrink tubing over the display connector of the cable assembly.
Connect the three wires from the end of the cable assembly to the appropriate terminals on the plug for the module.Note: Refer to the appropriate topic for the display that is being installed for more information on connecting the display module.
Repeat Step 3 for each module.
Connect the service tool connector.Note: If a customer supplied service tool connector is already installed, connect the J1939 data link to the existing connector.
Run the 153-2707 Cable (Shielded Twisted Pair) from the last 133-0970 Receptacle As (Tee) to the service tool connector. Cut the cable to length.Note: The total length from the 133-0970 Receptacle As (Tee) to the Communications Adapter should be no more than 1.00 m (3.25 ft).
Remove 25 mm (1.0 inch) of insulation from both ends of the cable.
Remove 7 mm (0.28 inch) of insulation from each end of the green wire and the yellow wire.
Crimp a 186-3736 Connector Socket on each end of the green wire and the yellow wire with a 1U-5804 Crimp Tool .
Crimp a 133-0969 Connector Socket (Extended) on each end of the shield with a 1U-5804 Crimp Tool .
Cut two 30 mm (1.2 inch) pieces of 5P-6001 Heat Shrink Tubing. Slide a piece of the heat shrink tubing over the shield at each end of the cable. Position the heat shrink tubing so that 1 cm (0.4 inch) of the socket is covered and the remaining tubing is covering the shield. Apply heat until a complete seal is formed around the shield and the socket. Be careful to avoid skin contact with any hot glue that may seep from the heat shrink tubing.
Cut two 50 mm (2 inch) pieces of 125-7876 Heat Shrink Tubing. Slide a piece of the heat shrink tubing over each end of the cable.
Insert the wires from one end of the data link into the service tool connector. See Table 7.
Table 7
Terminal Locations