HARNESS AS-DASH 1207433 - Caterpillar

Horn Switch
Illustration 11 g01943974
Left Joystick (2-Button, Slide, Trigger Switch)
(1) Horn Switch (SW-3)
(2) Horn Switch (SW-3) Connections Note: SW-2 is a trigger switch and is not shown in Illustration 11.One Touch Low Idle Switch
Illustration 12 g01145300
Right Joystick (2-Button, Slide, Trigger Switch)
(1) Low Idle Switch (SW-3)
(2) Low Idle Switch (SW-3) Connections Note: SW-2 is a trigger switch and is not shown in Illustration 12.The "One-Touch Low Idle" switch is located on the handle of the Right Joystick (See Illustration 12). The one touch low idle switch will automatically reduce engine speed to 1020 RPM. Both joystick handles (LH and RH) must be in the neutral position before the engine speed is reduced.Pressure Switch
Illustration 13 g00663092
Attachment Pump Pressure Switch (Hammer)
Attachment Pedal Pressure Switch (Hammer)
The pressure switch will monitor the hydraulic system. This switch is normally open. This switch will inform the controller about the status of the hydraulic demands. When there is no hydraulic demand, this switch is open. Key Start Switch
Illustration 14 g02140333
Key Start Switch
The key start switch is an input of the engine and pump controller. The key start switch informs the ECM of an attempt to start the engine. Then, the ECM initiates the start procedure.The starting switch is a four position switch, and connects the battery supply terminal B to the other terminals.Usually the position of the switch is the OFF position. At this time the connected terminals are the B and C terminals only.When the switch is in the ON position, the connected terminals are B and R only. The keyswitch will remain in this position without handling.When the switch is in the Start position, the connected terminals are B, R, and S. The keyswitch must be handled to remain in this position.When the keyswitch is in the EMERGENCY STOP position, the connected terminals are B and A only. The keyswitch must be handled to remain in this position.During normal machine operation, the start terminal of the key start switch is open. If the key start switch is placed in the START position, the start terminal will close. +Battery voltage is supplied to the start terminal. When all starting conditions are satisfied, the ECM sends a +battery signal to the start relay and engine cranking begins.Note: After the key start switch is initially turned to the START position, the switch will not return to the START position from the ON position. The switch must be turned to the OFF position first. Then, the switch can be turned to the START position.Toggle Switch
Illustration 15 g01157913
Backup Travel Right Hand Switch, Backup Boom Switch, Backup Travel Left Hand Switch, Neutral Start Limit Switch
Pedal Control
Illustration 16 g00629518
Attachment Pedal
(1) Schematic Symbol
(2) Attachment Pedal The pedal output is a pulse width modulated signal (PWM). The PWM output of the pedal in the center or neutral position is approximately 50 percent duty cycle. The PWM output of the pedal at the extreme limit is approximately 5 percent and 95 percent duty cycle. The factory defaults of the calibration settings for the pedal are 5 percent, 50 percent, and 95