HARNESS AS-POWER 1211044 - Caterpillar

Hot oil and hot components can cause personal injury. Do not allow hot oil or hot components to contact skin.
Illustration 1 g00104545
Prevent the machine from movement. Park the machine on a level surface.Attach a "Do Not Operate" warning tag or a similar warning tag to the start switch or to the controls before you service the equipment. These warning tags (Special Instruction, SEHS7332) are available from your Caterpillar dealer.Required Parts
Table 1
354-4381 Hydraulic Fitting Gp Revision -01    
Item    Qty    Part No.    Description    
(1)     1     196-2036     Tee As    
(2)     1     296-7059     Fitting As    
(3)     1     148-8378     Elbow As    
(4)     1     164-8908     Connector As    
Illustration 2 g02370876
Installation Procedure
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat products.Dispose of all fluids according to local regulations and mandates.
Note: Put identification marks on all hoses, on all hose assemblies, on all harness assemblies, and on all tube assemblies for installation purposes. Plug all hose assemblies and all tube assemblies. This helps to prevent fluid loss, and helps to keep contaminants from entering the system.
Release the hydraulic system pressure. Refer to your host machine Operation and Maintenance Manual, "System Pressure - Release".
Remove the access plates on the underside of the cab.
Illustration 3 g02370956
Disconnect hose assemblies (C) and (D). Remove fittings (A) and (B) .
Illustration 4 g02370957
Install tee assembly (1) in the port where fitting (A) (not shown) was previously removed. Connect elbow assembly (3) to tee assembly (1) as shown.
Install fitting assembly (2) in the port where fitting (B) (not shown) was previously removed. Connect connector assembly (4) to fitting assembly (2) .
Illustration 5 g02370958
Connect existing hose assembly (D) to tee assembly (1). Connect existing hose assembly (C) to connector assembly (4)
Connect hose assembly (E), from 325-8962 Pilot Lines Group , to elbow assembly (3) .
Tighten all hardware to standard torque.
Illustration 6 g00687600
Personal injury or death can result from escaping fluid under pressure.Escaping fluid under pressure, even a very small pin-hole size leak, can penetrate body tissue, causing serious injury, and possible death.Always use a board or cardboard when checking for a leak.Do not check for pin hole leaks in pump or motor hoses during a steer stall condition. If fluid is injected into your skin, it must be treated by a doctor familiar with this type of injury immediately.
Inspect the fittings for hydraulic leaks.