HARNESS AS-CAB 1244652 - Caterpillar

Illustration 27 g00900331
Remove O-ring seal (13).
Illustration 28 g00900330
Remove shims (14).
Illustration 29 g00900329
Illustration 30 g00903330
Install Tooling (C).
Remove the rotary group (14A) from the housing.
Illustration 31 g00900326
Remove Tooling (B).
Remove barrel (15).
Illustration 32 g00901525
Personal injury can result from being struck by parts propelled by a released spring force.Make sure to wear all necessary protective equipment.Follow the recommended procedure and use all recommended tooling to release the spring force.
Remove spring (16) from barrel (15).
Illustration 33 g00900325
Install spring (16) and correct shim thickness (17) into barrel (15).
Illustration 34 g00900326
Install barrel (15). Install Tooling (B) to secure barrel (15).
Illustration 35 g00903330Note: Raise the temperature of the housing to 80 °C (176 °F). Lower the temperature of the rotary group.
Install the rotary group (14A) into housing (2).
Illustration 36 g00706486
Remove Tooling (B).
Illustration 37 g00900330
Install shims (14).
Illustration 38 g00900331
Install O-ring seal (13).
Illustration 39 g00901350
Install cover (11).
Use Tooling (A) to install retaining ring (10).
Illustration 40 g00900341
Install control plate (4) in the original position.
Install O-ring seal (3).
Illustration 41 g00900342
Position port plate (2) in the original location.
Install bolts (1).End By:
Install the swing motor. Refer to Disassembly and Assembly, "Swing Motor - Install".