HARNESS AS- 1278861 - Caterpillar

Illustration 1 g00559405
(1) Stick Out
(2) Swing Right
(3) Stick In
(4) Swing Left
(5) Boom Lower
(6) Tool Open
(7) Boom Raise
(8) Tool Close
(9) HOLD
The Fine Swing Control delays the engagement of the swing parking brake.If the machine is operating on a slope with the Fine Swing Control in the ON position, the swing motion may become uncontrollable which could result in property damage, personal injury or death.Turn the Fine Swing Control to the OFF position when the machine is operating on a slope.
When you release the joysticks from any position, the joysticks will return to HOLD position (9). Movement of the upper structure will stop unless the fine swing control (if equipped) is ON. When the fine swing control is ON, the swing parking brake will not activate until 6.5 seconds after the joystick control for the swing function returns to the HOLD position.The machine control pattern is initially set at the factory to the SAE system, as shown. The pattern on the left pertains to the left joystick and the pattern on the right pertains to the right joystick.The machine control pattern can be varied. Refer to Operation and Maintenance Manual, "Joystick Controls Alternate Patterns" for more information.Two functions may be performed at the same time by moving a joystick diagonally.Rotating Tool Control
Illustration 2 g00875108
(A) Left joystick
(B) Right joystick
(1) Medium pressure switch
(2) Horn switch
(3) Medium pressure switch
(4) AEC switch
Rotate Clockwise - Press the medium pressure switch (1) on the left joystick in order to rotate the tool clockwise.
Horn - Press the horn switch (2) on the left joystick in order to activate the horn.
Rotate Counterclockwise - Press the medium pressure switch (3) on the right joystick in order to rotate the tool counterclockwise.
AEC Switch - Press the AEC switch (4) on the right joystick in order to activate low engine speed. Press the switch again in order to activate high engine speed.