HARNESS AS 1321947 - Caterpillar

1. Remove brackets (1) from the storage position on each side of the dash. Turn brackets (1) over and install them as shown to hold the dash to the loader frame when the cab is tilted. 2. Remove the floormat from the cab. Remove the five bolts (4) and fourteen plugs (2).3. Disconnect wiring harness (3) from the cab wiring harness. 4. Remove plastic covers (5) from the inside front corners of the cab.5. Remove bolts (6) that hold the cab to the dash. 6. Remove the plate from the side of the tilt and lift control console. Disconnect linkage (7) from the lift control lever. Disconnect linkage (8) from the tilt control lever.
Do not smoke when an inspection of battery electrolyte level is made. Batteries give off flammable fumes. Do not let electrolyte solution make contact with skin or eyes. Electrolyte solution is an acid. Connect ground cable last, and remove first, to prevent sparks near the battery, which can cause battery vapors to burn fast with much expansion and force (explode).
7. Open the access door on the left side of the machine and remove the tool box. 8. Make sure the disconnect switch is in the "OFF" position. Disconnect back-up alarm and horn wiring harness (9) from wiring harness (11). Disconnect cables (10) and (12) from the batteries. Disconnect cable (13) from the disconnect switch. 9. Remove the clip and pin (15) to disconnect rod (16) from the transmission and governor control lock lever. Disconnect rod end (14) from the governor control lever. 10. Remove plate assembly (17) from the left side of the machine. 11. Remove two bolts (18) to disconnect the transmission control linkage from the control lever. 12. Remove bolts (19) and the washers that hold each side of the cab to the loader main frame.13. Install tooling (A) on the right side of the cab and main frame as shown.
Remove all loose objects from the cab before it is tilted. Make sure the cab doors are latched open or closed.
14. Slowly tilt the cab back with tooling (A) until the cab is in contact with bracket assembly (20). 15. Put bracket (21) in position and install the bolt and nut to hold it to bracket assembly (20). Tighten the bolt and nut hand tight only. Bracket (21), the bolt and nut are kept in storage in the tool box.Tilt Cab Forward (955L)
1. Remove bracket (1) from bracket assembly (2).2. Use tooling (A) and slowly tilt the cab forward. 3. Install the bolts and washers to hold the front of the cab to the loader main frame. Tighten the bolts to a torque of 350 37 lb.ft. (475 50 N m). 4. Remove tooling (A) from the machine. 5. Install the bolts to connect the linkage to the transmission control lever (3). After the transmission linkage, transmission lock linkage and governor control linkage is connected, make sure they are in correct adjustment. See TESTING AND ADJUSTING section. 6. Install plate