HARNESS AS-PANEL 1339008 - Caterpillar

Disassembly Procedure
Table 1
Required Tools    
Tool     Part Number     Part Description     Qty    
A     311-0964     Compressor Gp     1    
B     196-5056     Hydraulic Cylinder Gp     1    
3S-6224 Hydraulic Cylinder Gp     1    Start By:
Remove the recoil spring assembly. Refer to Disassembly and Assembly, "Recoil Spring - Remove".
Personal injury or death can result from recoil spring force. Recoil spring force, if not relieved, can result in personal injury or death.Relieve spring force before removing threaded retainer, performing repairs on recoil spring housing, or removing recoil spring.
Illustration 1 g01372847
Illustration 2 g01372849
Assemble Tooling (A) onto the recoil spring assembly, as shown. Attach Tooling (B) to Tooling (A) . A suitable press can be used in place of Tooling (B) . Use Tooling (B) to apply pressure onto plug (2) in order to compress the spring.
Remove bolts (1) and the washers.
Illustration 3 g01372880
Release the pressure on Tooling (B) , or a suitable press, in order to release the tension on spring (3) . Spring (3) should move freely at this time. Remove Tooling (B) .
Illustration 4 g01372871
Remove nuts (4) . Remove plate (5) .
Illustration 5 g01372875
Remove flange (6) . Remove plug (2) .
Use two people to remove spring (3) . The weight of spring (3) is approximately 32 kg (70 lb).
Illustration 6 g01373010
Remove rods (7) and remove sleeves (8) .
Use two people to remove tube assembly (9) from plate (10) . The weight of tube assembly (9) is approximately 32 kg (70 lb).