HARNESS AS-CAB 1356086 - Caterpillar

Removal Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A 311-1362 Vacuum Cap 1 Start By:
Release the system pressure.
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat® products.Dispose of all fluids according to local regulations and mandates.
Illustration 1 g01368952
Install Tooling (A) onto the hydraulic tank. Attach an air supply hose onto Tooling (A). Apply 138 kPa (20 psi). This procedure will pull a vacuum on the hydraulic system.
Illustration 2 g01007360
Personal injury can result from the sudden release of high pressure oil.Be sure the engine has been shut off for a minimum of five minutes to ensure that the accumulator pressure is zero.The accumulator is filled with dry nitrogen. Do not loosen or remove the valve or the cap from the top of the accumulator.
Disconnect harness assembly (1).
Remove nut (2), washer (3), and coil assembly (4).
Illustration 3 g01007361
Remove cartridge assembly (5).Installation Procedure
Install the solenoid valve (blade cushion) in the reverse order of removal.
Tighten cartridge assembly (5) to a torque of 169 7 N m (125 5 lb ft).
Tighten nut (2) to a torque of 9.5 1.5 N m (84.08 13.28 lb in).