HARNESS AS-CONTROL 1472763 - Caterpillar

Removal Procedure
Start By:
Lower the front crankcase guard. Refer to Disassembly and Assembly, "Crankcase Guard - Remove and Install".
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat® products.Dispose of all fluids according to local regulations and mandates.
Note: Put identification marks on all hoses, on all hose assemblies, on all wires, and on all tube assemblies for installation purposes. Plug all hose assemblies and all tube assemblies. This helps to prevent fluid loss, and this helps to keep contaminants from entering the system.
Drain the coolant from the cooling system into a suitable container for storage or disposal. Refer to Operation and Maintenance Manual, "Cooling System Coolant (ELC) - Change".
Illustration 1 g01164454
Disconnect hose assemblies (1).
Illustration 2 g01164456
Loosen clamps (2) and (3). Remove hose (4).
Loosen clamps (6). Remove oil cooler (5).
Illustration 3 g01164460
Remove bonnet (7) and the gasket from oil cooler (5).
Remove flange (8) and the O-ring seal from oil cooler (5).
Remove flange (9) and the O-ring seal from oil cooler (5).
Remove bonnet (10) and the gasket from oil cooler (5).