HARNESS AS 1516175 - Caterpillar

Hot oil and components can cause personal injury.Do not allow hot oil or components to contact skin.
Clean the oil suction screen at every oil change. Clean the oil suction screen after the oil sump has been drained.Note: Approximately 1 L (1 qt) of oil will remain in the housing after the sump has been completely drained. This oil will pour out of the housing when cover (1) is removed. Catch the oil with a pan. Clean up any spilled oil with absorbent pillows or towels. DO NOT use absorbent particles to clean up the oil.
Illustration 2 g00701472
Remove the bolts and washers from cover (1). Remove cover (1) and the O-ring seal. Inspect the seal for good condition. If the seal is cut, scratched, or cracked, obtain a new seal for assembly.
Illustration 3 g00745695
Slide screen assembly (2) from the tube.
Wash screen assembly (2) in clean nonflammable solvent. Allow the screen assembly to dry before installation.
Install screen assembly (2). Install cover (1) and the O-ring seal. Secure the cover with the bolts and washers.Replace the Engine Oil filters
Replace the engine oil filters for any of the following occurrences:
Every oil change
The engine oil filter differential pressure reaches 100 kPa (15 psi).Service tools are available to aid in the service of oil filters and fuel filters. Consult your Caterpillar dealer for the part names and the part numbers. Follow the instructions that are supplied with the service tools. If the service tools are not used, perform the following procedure.
Hot oil and components can cause personal injury.Do not allow hot oil or components to contact skin.
Perform the following procedure after the oil sump has been drained.
Illustration 4 g00745696
Connect a hose from each drain valve (1) to a suitable container in order to catch the oil.
Open both drain valves (1). Allow the oil to drain.Note: Some oil will remain in the housing after the oil has been drained. This oil will pour out of the housing when cover (2) is removed. Catch the oil with a pan. Clean up any spilled oil with absorbent pillows or towels. DO NOT use absorbent particles to clean up the oil.
Personal injury can result from parts and/or covers under spring pressure.Spring force will be released when covers are removed.Be prepared to hold spring loaded covers as the bolts are loosened.
Be alert to the spring force. Cover (2) has a spring force up to 240 N (54 lb). Gradually loosen but do not remove the last two bolts or nuts that are located at opposite corners of the cover. Before removing the last two bolts or nuts, pry the cover loose in order to relieve any spring pressure.
Illustration 5 g00745697
(2) Cover (3) O-ring seal (4) Spring (5) Retainer (6) O-ring seal (7) O-ring seal (8) Filter
Remove cover (2). Inspect O-ring seals (3), (6), and (7) for good condition. If a seal is cut, scratched, or cracked, obtain a new seal for assembly.
Remove spring (4) and retainer (5) .
Use a pan to catch the oil that drips when the filters are removed. Remove the