HARNESS AS-ENGINE 1591191 - Caterpillar

With the engine running, this machine spot turns when the steering wheel is turned, even with the transmission in NEUTRAL and the parking brake or service brake engaged.To avoid personal injury due to unexpected machine movement, make sure the area is free of personnel before starting the engine.DO NOT STEER when starting the engine. If machine does not steer, stop the engine.
Engine Starting Above 0°C (32°F)
1. Move the transmission control lever into NEUTRAL. 2. Engage the parking brake. 3. Move the implement control levers to the HOLD position. 4. Place the governor control lever in the LOW IDLE position.5. Depress the inching clutch pedal.6. Turn the engine start switch key to the ON position. 7. The parking brake indicator light should come on.8. Turn the engine start switch key to START. Release the switch key when the engine starts.Engine Starting Below 0°C (32°F)
1. Follow Steps 1 through 7 for Engine Starting Above 0°C (+32°F).2. Turn the engine start switch key to START.
Inject starting aid (ether), only while cranking the engine.Use sparingly, excessive ether can cause piston and ring damage.Wait approximately two seconds before injecting again.Use ether for cold starting purposes only.After every 30 seconds of engine cranking, allow two minutes for starting motor to cool before cranking again.Turbocharger damage can result, if the engine rpm is not kept low until the engine oil light/gauge verifies the oil pressure is sufficient.
3. Push the starting aid (ether) switch and release.4. Operate the starting aid switch every two seconds while cranking the engine. Continue use until the engine starts.5. Release the start switch key when the engine starts.For starting below -9°C (+15°F), the use of an engine block heater may be required.At temperatures below -18°C (0°F), consult your Caterpillar dealer, or refer to the Cold Weather Recommendations Operation and Maintenance Manual, SEBU5898, available from your Caterpillar dealer.Engine Starting With Jumper Cables
Batteries give off flammable fumes that can explode.Prevent sparks near the batteries. They could cause vapors to explode. Do not allow jump cable ends to contact each other or the machine.Do not smoke when checking battery electrolyte levels.Electrolyte is an acid and can cause personal injury if it contacts skin or eyes.Always wear eye protection when starting a machine with jump cables.Improper jump procedures can cause an explosion resulting in personal injury.Always connect battery positive (+) to battery positive (+) and battery negative (-) to battery negative (-).Jump only with a battery source and with the same voltage as the stalled machine.Turn off all lights and accessories on the stalled machine. Otherwise, they operate when the jump source is connected.When starting from another machine, make sure the machines do not touch. This could prevent damage to engine bearings and electrical circuits.Turn on (close) the battery disconnect switch prior to the boost connection to prevent damage to electrical components on the stalled machine.Severely discharged maintenance free batteries do not fully recharge from the alternator alone after jump starting. The batteries must be charged to the proper voltage with a battery charger. Many