HARNESS AS-WIRING 1668366 - Caterpillar

Installation of the 261-3226 Camera Display
Removal of the Bracket for the Right Hand Mirror
Remove the overhead console.
Remove the right-hand mirror from the bracket.
Loosen and drop down the headliner.
Remove the bracket for the right-hand mirror.Installation of the 255-4368 Bracket
Illustration 10 g01192922
View of mounted display monitor
Use the bolts from the bracket for the right-hand mirror and install the 255-4368 Bracket (7) .
Raise the headliner over the 255-4368 Bracket (7). Use two 9X-2040 Screws (20) and install the 278-0123 Bracket As (19) onto the 255-4368 Bracket (7) .
Use The following hardware and install the 261-3226 Camera Display Gp (12) onto the 278-0123 Bracket As (19) :
Four 5C-9553 Bolts (17)
Four 8T-4205 Hard Washers (18)
Illustration 11 g01138271
View of connectors for the display monitor
Route cables (A) and (B) above the headliner near the 255-4368 Bracket (7) .
Connect one end of the 263-2166 Harness Assembly (15) onto the power lead (A) of the 261-3226 Camera Display Gp .
Connect one end of a 251-8248 Cable As (10) onto the signal cable (B) of the 261-3226 Camera Display Gp .
Route the 263-2166 Harness Assembly (15) and the 251-8248 Cable As (10) above the headliner to the right-hand door post. Then route the cables down the door post along the existing harness to the floor in the rear of the cab behind the seat.
Illustration 12 g01138668
View of dimmer control connector (A) Dimmer control connector
Disconnect the dimmer control plug and connect the plug to the 263-2166 Harness Assembly (15). Then connect the end of the 263-2166 Harness Assembly (15) to the dimmer control connector.Installation of the 333-8153 Connector Group
Illustration 13 g01171961
View of the end plate in cab
Use the 333-8153 Connector Group as a guide and drill a 22.5 mm (0.8858 inch) hole in the end plate. Be careful not to damage the existing internal wiring or the existing external wiring.Note: Go to the next step If there is not enough room on the end plate for the plug.
Illustration 14 g01322371
View of the end plate in cab (A) 25.40 mm (1 inch) (B) 76.2000 mm (3 inch)
If there is not enough room on the end plate for the plug, refer to Illustration 14. Drill a 22.5 mm (0.8858 inch) hole by using the dimensions in callout (A) and in callout (B). Be careful not to damage the existing internal wiring or the existing external wiring.
Install the 333-8153 Connector Group (9) into the 22.5 mm (0.8858 inch) hole. Note: Screws that were supplied with the connector are not required.
Connect the other end of the 251-8248 Cable As onto the 333-8153 Connector Group (9) .
Connect the other end of the cable assembly that comes from the camera onto the outside of the 333-8153 Connector Group (9) .
Check the operation of the camera and adjust if necessary. Note: Some part of the machine must be visible in the monitor. Preferably, the bumper should be seen in the monitor.
Tighten the mounting hardware for the camera when the camera