HARNESS AS-WRG 1670722 - Caterpillar

Illustration 1 g01964861
Schematic of the Temperature Sensor (Steering Oil)
This diagnostic code is associated with the Temperature Sensor (Steering Oil). The FMI 03 means that the ECM has determined that the voltage of the circuit for the sensor is above normal.The possible causes of this diagnostic code are listed below:
The signal circuit for the sensor is open.
The signal circuit for the sensor is shorted to the +battery circuit.
The sensor has failed.
The power circuit or the ground circuit has failed.
The ECM has failed. An ECM failure is unlikely.Note: The following test procedure may create other diagnostic codes. Ignore these created diagnostic codes and clear the diagnostic codes when the original diagnostic code has been corrected. Ensure that the diagnostic code of CID 0075 FMI 03 is active before performing this procedure.Note: Use the 146-4080 Digital Multimeter for the measurements in this procedure.
Table 1
Temperature Resistance (Ohms)
−50° C (−58° F) 2724Ω
11° C (52° F) 167Ω
50° C (122° F) 44Ω System Response:The diagnostic code of CID 0075 FMI 03 will be logged in the internal memory of the ECM.Test Step 1. CHECK FOR POWER AT THE SENSOR.
Do not disconnect the harness connector from the sensor.
Turn the key start switch and the disconnect switch to the ON position.
At the back of the harness connector for the sensor, insert a 7X-1710 Multimeter Probe along the voltage supply wire (contact 1).
Measure the voltage from contact 1 to frame ground. Expected Result:The voltage is 5VDC.Results:
OK. - The voltage is 5VDC. Proceed to Test Step 2.
NOT OK. - The voltage is not 5VDC. The +battery circuit in the machine harness has failed.Repair: Replace the machine harness or repair the machine harness.STOPTest Step 2. CHECK FOR PROPER GROUND AT THE SENSOR.
The machine harness remains connected to the sensor.
Turn the key start switch and the disconnect switch to the OFF position.
Remove the 7X-1710 Multimeter Probe from the voltage supply wire (contact 1).
At the back of the harness connector for the sensor, insert a 7X-1710 Multimeter Probe along the ground wire (contact 2).
Measure the resistance from contact 2 to frame ground. Expected Result:The resistance is less than 5Ω.Results:
OK. - The resistance is less than 5Ω. The ground circuit is correct. Proceed to Test Step 3.
NOT OK. - The resistance is greater than 5Ω. The ground circuit in the machine harness has failed.Repair: Replace the machine harness or repair the machine harness.STOPTest Step 3. CHECK THE WIRING HARNESS OF THE SENSOR FOR AN OPEN CIRCUIT.
The key start switch and the disconnect switch remain in the OFF position.
Disconnect the machine harness from the sensor.
At the harness connector for the sensor, connect a jumper wire between contact 2 and contact 1.
Disconnect the machine harness connectors from the ECM.
At the harness connector for the ECM, measure the resistance between contact J1-21 wire (998-BR(Brown)) and contact J1-53 wire (M975-BU(Blue)). Expected Result:The resistance measurement is less than 5Ω.Results:
OK. - The resistance measurement is less than 5Ω. The circuit is correct. Proceed to Test Step 4.
NOT OK. - The resistance is greater than 5Ω. The