HARNESS AS-CHASSIS 1714405 - Caterpillar

Removal Procedure
Start By:
Release the pressure in the hydraulic system. Refer to Disassembly and Assembly, "System Pressure - Release".
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide" for tools and supplies suitable to collect and contain fluids on Caterpillar products.Dispose of all fluids according to local regulations and mandates.
Personal injury can result from hydraulic oil pressure and hot oil.Hydraulic oil pressure can remain in the hydraulic system after the engine has been stopped. Serious injury can be caused if this pressure is not released before any service is done on the hydraulic system.Make sure all of the attachments have been lowered, oil is cool before removing any components or lines. Remove the oil filler cap only when the engine is stopped, and the filler cap is cool enough to touch with your bare hand.
Personal injury can result from the sudden release of high pressure oil.Be sure the engine has been shut off for a minimum of five minutes to be sure that the accumulator pressure is zero.The accumulator is filled with dry nitrogen. Do not loosen or remove the valve or cap from the top of the accumulator. A purge screw at the bottom of the accumulator can be used to release the pressure that is left in the system.
Illustration 1 g01056114
Remove cover (1) .
Illustration 2 g01056115
Disconnect tube assembly (3). Remove bolts (4). Remove ride control accumulator (2) .Installation Procedure
Illustration 3 g01056115
Position ride control accumulator (2) and install bolts (4). Connect tube assembly (3) .
Illustration 4 g01056114
Install cover (1) .