HARNESS AS-HEATER 1743070 - Caterpillar

Illustration 1 g03340422Alert Indicators
Action Lamp (1) - This indicator flashes to indicate a Warning Category 2 or a Warning Category 3 has been registered by the Caterpillar Monitoring System. For more information refer to Operation and Maintenance Manual, "Caterpillar Monitoring System".
Hydraulic Oil Level (7) - This indicator will be on when the hydraulic oil level is low. If this alert indicator flashes during operation, stop the machine immediately and engage the parking brake. Stop the engine and investigate the cause.Indicators
Automatic Lubrication Indicator (2) (Electric Type) (If Equipped) - This indicator will be on when the automatic lubrication system is in operation.
Automatic Lubrication Indicator (2) (Hydraulic Type) (If Equipped) - This indicator will be on when there is a fault in the automatic lubrication system. Report the fault to service personnel when convenient. This indicator will be on for 2 seconds after the engine starts in order to alert the operator that the indicator is functioning properly. The operator must inspect this indicator after the engine starts. If the indicator does not come on or glows dimly after startup, or if the indicator remains on, stop the engine, and find the cause.
Exhaust Back Pressure Indicator (3) (If Equipped) - Indicates high exhaust back pressure. If back pressure is over 6 kPa (25 inches H2O), the light will illuminate and the exhaust purifilter must be cleaned.
Primary/Secondary Steering Indicator (4) (If Equipped) - This indicator will be on if there is a steering system failure in either the primary or secondary steering systems.Note: The secondary steering system only operates while the machine is moving.
If the primary/secondary steering indicator flashes, cease operation, quickly move the machine to a safe area and shut the machine down. Inspect and rectify the cause of the problem before recommencing operation.
Residual Brake Oil Pressure Indicator (5) (If Equipped) - Indicates that there is oil pressure in the service brake section of the wheel brakes. The lamp will illuminate when the service brakes are applied. The lamp should go out when the brakes are released. If this indicator stays on, the brakes are holding residual brake oil pressure. Stop the machine and investigate the cause.
Ride Control Indicator (6) (If Equipped) - Indicates the ride control system is activated.