HARNESS AS-BOX 1833051 - Caterpillar

Introduction
Hydraulic oil may be seeping from the oil seal in the hook and/or the boom winch. This is possibly caused by excessive flushing of oil that is routed to the winches. This Special Instruction contains the necessary procedures and information in order to increase the diameter of the hose on the bypass line from the distribution manifold.Do not perform any procedures until you read the information and you understand the information that is contained in this manual. Do not order any parts until you read the information and you understand the information that is contained in this manual.
Do not attempt to assemble this machine until you read and you understand the assembly instructions.Improper assembly procedures could result in injury or death.
Do not allow any dirt or foreign material to get into the hydraulic system during assembly, connection of lines, when components are filled with fluid, or during any maintenance operation.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide" for tools and supplies suitable to collect and contain fluids on Caterpillar products.Dispose of all fluids according to local regulations and mandates.
Installation Procedure
Table 1
Required Parts    
Part Number     Description     Quantity    
305-3735     Hose Assembly     1    The following machines can be updated by following the procedures that are shown below:
(S/N: 2HZ1-UP)
(S/N: AAC1-UP)
(S/N: DSC1-301)
Remove the floor mat.
Remove both floorplates.
Remove a section of the guard for the right hand lines.Following Step 1 through Step 3 will expose the distribution manifold, the return manifold, and 156-1778 Hose Assembly .
Illustration 1 g01519297
Illustration 2 g01519300
Replace 156-1778 Hose Assembly (1) with 305-3735 Hose Assembly .
Reassemble the guard for the lines, both floorplates, and the floor mat.