HARNESS AS 1864665 - Caterpillar

Connection Procedure
Table 1
Required Tools    
Tool    Part Number    Part Description    Qty    
A     260-9412     Chain As     1    
B     5P-6214     Track Block Assembly     2    
C     5P-2379     Track Press Tool Gp     1    
8S-7172 Double Acting Cylinder     1    
8S-9903 Track Press Rollover Gp     1    
D     5P-0960     Grease Cartridge     1    
Illustration 1 g01206205
Use a Tooling (A) in order to position the track assembly. Raise the track until the pin bores in the track links are in alignment. Install Tooling (B) in position under the track shoe.
Illustration 2 g01998554
Install seals (4) into the link (5). Apply Tooling (D) to the lip of seals (4) .
Illustration 3 g02000099
Illustration 4 g02024000
Dimension (X) equals 2 mm (0.080 inch).
Use Tooling (C) in order to install master pin (3). Master pin (3) must be centered on the track link. Install master pin to a depth of approximately 2 mm (0.080 inch).Note: Do not allow any grease to be on the end of the pin. Grease on the end of the pin can cause the tooling to slip during the installation.
Illustration 5 g01167154
Use Tooling (A) in order to position track shoe (2). Install bolts (1). Tighten bolts (1) to the correct torque. Refer to Table 2. Tighten bolts (1) to an additional 120 degrees.
Table 2
Torque Values for Track Bolts    
Machine     Torque    
325 to 329    
400 70 N m (295 52 lb ft)    
330 to 336    
500 70 N m (369 52 lb ft) (1)    
600 70 N m (443 52 lb ft) (1)
( 1 ) Only apply the higher torque value if you install 143-4891 Track Bolts or 216-4025 Track Bolts .
Illustration 6 g01174955
Personal injury or death can result from grease and oil coming out of the relief valve.Grease and oil are under high pressure coming out of the relief valve and can penetrate the body.Do not watch the relief valve to see if grease is escaping. Watch the track or track adjustment cylinder to see if the track is being loosened. Make sure the vent holes are clean before the tension is released on the track.
Remove Tooling (B) from both ends of the track assembly.
Adjust the track tension. Refer to Operation and Maintenance Manual, "Track Adjustment - Adjust".