HARNESS AS-PLATFORM 2067597 - Caterpillar

Table 1
Diagnostic Codes Table
Description Conditions which Generate this Code System Response
MID 0036 - CID 0268 - FMI 02 Check Programmable Parameters The engines Electronic Control Module (ECM) detects that one or more of the programmable parameters have not been programmed. The code is active.
The ECM may use a default torque map or the ECM may limit the engine to low idle.
MID 0036 - CID 1495 - FMI 02 Injector Trim Codes Not Programmed The engines ECM detects that one or more of the injector trim codes have not been programmed. System configuration parameters are parameters that affect emissions and power of the engine applications. Default values for the parameters are programmed at the factory. Some parameters may be changed by the customer to suit the needs of the specific application. Proper values for these parameters are available on the electronic service tool. Certain configuration parameters are also stamped on the engine information plate.No password is required for programming a new Electronic Control Module (ECM) during the first 100 hours of service life. This 100 hour “free configuration” feature enables the customer to tailor the programmable setpoints to the requirements of the installation. Exceptions are "Fuel Limit" and "Personality Module Mismatch".Note: If the parameters that are protected with the factory passwords are changed, the Caterpillar warranty may be voided.Parameter Table
Table 2
System Configuration Parameters
Parameter Default Range Password
"Engine Serial Number" 00000000 8 alphanumeric characters Yes
"Equipment ID" 00000000000000000 17 alphanumeric characters No
"Full Load Setting (FLS)" Not Programmed −128 to +127 Yes
"Cold Cylinder Cutout" Enabled Enabled
Disabled No
"Fuel Ratio Control Offset" 0 −25 to 0 No
"Ether Injection" Enabled Enabled
Disabled No
"Oil Renewal" Disabled Enabled
Disabled Yes
"Personality Module interlock - Rating" (1) (1) Yes
"Personality Module interlock - ECM" (1) (1) Yes
"Prelube" Disabled Enabled
Disabled Yes
"Shutter Control" Disabled Enabled
Disabled No
(1) The "Personality Module" interlock is automatically programmed by the ECM after factory passwords have been entered.Injector Trim Code
Note: The injector trim code is not part of the "Configuration" screen on Caterpillar Electronic Technician (ET). "Injector Codes Calibration" can be found under "Calibrations" in the "Service" menu on Cat ET.During the manufacturing process, a four-digit code is etched on the top surface of the injectors tappet to designate the trim code of the injector. The ECM uses this number to compensate for manufacturing variations between individual injectors. If you replace any of the unit injectors, you must reprogram the injector trim codes for the new injectors. Also, if you replace the ECM, you must reprogram all the injector trim codes.
Table 3
Injector Trim Code
Injector Default Range Password
"Inj #1