HARNESS AS 2225906 - Caterpillar

Reference: Special Instruction, Form No. SEHS6713 has complete specifications and procedures for crankshaft reconditioning.(1) Thickness of thrust plate (new) ... .1850 .0015 in.(4.699 0.038 mm) The width between the shoulders of the rear main bearing (journal) is 1.5935 .0025 in. (40.47 0.06 mm). Install 2P716 Thrust Plate.(2) Make reference to MAIN BEARINGS and BEARING SURFACE (JOURNAL) FOR MAIN BEARINGS.(3) Make reference to CONNECTING ROD BEARINGS and BEARING SURFACE (JOURNAL) FOR CONNECTING RODS.(4) Tighten plugs to ... 17 3 lb. ft.(23 4 N m)Then "stake" the crankshaft to hold the plugs in place. "STAKE" use a center punch and a hammer to change the shape of the hole as shown.(5) Crankshaft gear: Do not heat gear to more than 600° F (316°C).(6) End play for crankshaft (new) ... .0025 to .0145 in.(0.064 to 0.368 mm) Maximum permissible end play for crankshaft (worn) ... .025 in.(0.64 mm)(7) Dimension for installing rear wear sleeve ... .31 in.(7.8 mm)(8) Wear sleeve installation (use either method): a. Heat sleeve and install. Do not heat sleeve to more than 600°F (316°C).b. Push sleeve into position with correct tooling. Make reference to Special Instruction, Form No. GMG00240 for instructions and the correct tooling for installing wear sleeves.