HARNESS AS-WIRING 2239284 - Caterpillar

At operating temperature, the hydraulic oil is hot and under pressure. Hot oils can cause burns.To prevent possible personal injury, release the pressure in the implement hydraulic circuit (boom, stick, bucket, and swing), travel circuits, and the hydraulic oil tank at the filler cap before any hydraulic lines or components are disconnected or removed.Remove the filler cap only when the engine is stopped and the filler cap is cool enough to touch.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before operating any compartment or disassembling any component containing fluids.After collecting all fluids in suitable containers, dispose of all fluids according to local regulations and mandates.
Close the jaws of the work tool. Place the work tool on the ground and shut off the engine of the host machine.
Release the hydraulic pressure for the host machine. Refer to the Service Manual for the host machine.
Inspect the swivel of the work tool for hydraulic leaks. Inspect the hydraulic hoses and all of the hydraulic fittings for the cylinder. If there is external evidence of leakage around the swivel, you must repair the swivel. Refer to the Service Manual, "Swivel - Disassemble". If there is external evidence of leakage around any of the hoses or the fittings, you must repair the leaks.Note: Before you test the cylinder for leakage, you must test the swivel for leakage. Refer to the Service Manual, "Swivel Leakage - Test".
Illustration 1 g00750797
Close the ball valve for the jaw open circuit. The ball valve is mounted on the stick of the host machine.
Install an 8T-0860 Pressure Gauge in test port (1). Test port (1) is in the jaw open circuit.
Start the engine of the host machine. Allow the hydraulic system to rise to operating temperature.
Move the control for the work tool to the jaw close position. Hold the control in the jaw close position for a short period of time.
Make a note of any change in the pressure reading on the pressure gauge. If the pressure increases, the seals in the hydraulic cylinder may need to be replaced.