HARNESS AS-BOX 2242862 - Caterpillar

"Machine Radio Configuration"
The "Machine Radio Configuration" utility allows you to change the network number or the frequency channel on Data Radios. The "Machine Radio Configuration" utility runs on the Display.To open the "Machine Radio Configuration" dialog, complete the following steps:
In Service mode, select the "Installation" Soft Key from the "Setup" menu.
Illustration 1 g01301490
Press the up arrow or the down arrow until "Machine Radio Configuration" is highlighted.
Press the "OK" key. The utility automatically attempts to connect to the radio.
Illustration 2 g01301489
Use the Arrow Keys (8) in order to select the same network as the base station for TC900C Radios. Use the Arrow Keys (8) to select the same frequency as the base station for TC450C Radios."Display's Radio Port"
When a third party radio is used, the Display for the AccuGrade System allows the user to adjust the following communication parameters:
Baud Rate
ParityThe "Display's Radio Port" settings sets the speed at which the Display communicates with the radio. These settings do not affect the speed of data transfer though the air between radios. Refer to the following Steps in order to adjust the "Display's Radio Port" settings.
Illustration 3 g01265962
(1) LCD (2) Soft Key Labels (3) Soft Keys (4) Escape Key (5 ) Next Key (6) Power Key (7) "+" Key (8) Arrow Keys (9) "-" Key (10) "OK" Key (11) Menu Key (12) "Data Card Slot"
To view all options in the "Setup Menu" dialog you must start the AccuGrade System in "Service" mode.Note: Hold the "OK" Key (10) while pressing the Power Key (6) in order to start the AccuGrade System in "Service" mode.
Press the Menu Key (11) until the Soft Key Label "Setup Menu" is shown. Press the Soft Key (3) beside the "Setup Menu" Soft Key Label.
Select the Soft Key that is located beside the "Installation" Soft Key Label from the "Setup" menu.
Illustration 4 g01288056
Press the up arrow or the down arrow until "Display's Radio Port" is highlighted.
Illustration 5 g01288144
Press the "OK" Key (10) .A screen that is similar to Illustration 5 will appear.
Press the up arrow or the down arrow in order to adjust the "Baud Rate". Press the Next Key (5) in order to toggle between the Display Radio Port fields
Press the up arrow or the down arrow in order to adjust the "Parity".
Press the "OK" Key (10) .