HARNESS AS-CHASSIS 2278670 - Caterpillar

Do not check for leaks with your hands. Pin hole (very small) leaks can result in a high velocity oil stream that will be invisible close to the hose. This oil can penetrate the skin and cause personal injury. Use cardboard or paper to locate pin hole leaks.
Check for leaks.Inspect all oil lines, hoses, and connections for damage or for leaks. Look for oil on the ground under the machine.Note: If oil can leak out of a fitting or a connection, air can leak into the system. Air in the system can be as bad as a low amount of oil.
Check the electrical system.Inspect the fuse for the power train electronic control module, the harnesses, and the electrical connectors. Refer to the proper Electrical Schematic.With the engine start switch and the battery disconnect switch in the OFF position, check the 10 ampere fuse for the power train electronic control module. If the fuse is open, replace the fuse.Inspect the electrical harnesses for damaged wires or for broken wires. Disconnect each connector and look for pins and sockets that have been bent, broken, or removed. Look for any foreign material inside the connectors. The connectors must be tightened with normal force. The connectors must be disconnected with the same amount of force.Check the power train electronic control module. For procedures, refer to the power train electronic control system.
Check the batteries.Turn the battery disconnect switch ON.
Check the filters and the screens.Inspect the power train oil filter, the transmission magnetic screen, and the suction screen.Note: The power train oil filter has a bypass valve. A bypass valve allows oil to bypass the oil filter elements whenever the difference in pressure between the inlet oil and the outlet oil in the oil filter is too high. Any oil that does not go through the filter elements goes directly in the hydraulic circuit. Dirty oil causes restrictions in the valve orifices, the sticking valves, etc.If any contamination is found in the filter elements or the screens, all the components of the transmission hydraulic system must be cleaned. Do not use any damaged parts. Any damaged parts must be removed and new parts must be installed.