HARNESS AS-TRANSMISSION 2313529 - Caterpillar

Install Tooling (A) in order to support ejector cylinder (1) in the horizontal position.
Install clip (17) .
Connect hose assemblies (15), (16) and (18) .
Repeat Step 1 through Step 16 for the other ejector cylinder.
Illustration 7 g01402292
Lower the temperature of bearing (14) to −75° 5°C (−103° 9°F). Use Tooling (K) to install bearing (14) to a depth of 9.5 1 mm (0.37 0.04 inch) below the surface of the bore.
Use Tooling (L) to install lip seal (13). Install lip seal (13) with the sealing lip towards the outside of the main ejector plate assembly.
Repeat Step 18 and Step 19 for the other side of the main ejector plate assembly.
Illustration 8 g01402291
Attach a suitable lifting device to lower ejector plate assembly (11). The weight of lower ejector plate assembly (11) is approximately 170 kg (375 lb).
Apply Tooling (J) to the bores of lower ejector plate assembly (11) and main ejector plate assembly (7) .
Align the bores of lower ejector plate assembly (11) and main ejector plate assembly (7).
Use two people in order to install the hinge pin. The weight of the hinge pin is approximately 25 kg (55 lb).
Apply Tooling (J) to the threads of bolts (12) prior to assembly.
Install two bolts (12), and the washers. Tighten bolts (12) to a torque of 430 60 N m (315 45 lb ft).
Illustration 9 g01401962
Install Tooling (C), Tooling (D) and a suitable lifting device to main ejector plate assembly (7). The weight of main ejector plate assembly (7) with the lower ejector plate assembly attached is approximately 1180 kg (2600 lb).
Illustration 10 g01402290
Apply Tooling (M) to the bores of the ejector bucket and the bores of the main ejector plate assembly.
Align the bores of the ejector bucket with the bores of the main ejector plate assembly.
Install shims (10) (not shown) as required between the ejector bucket and the main ejector plate assembly.
Install pin (9) .
Apply Tooling (J) to the threads of bolt (8) prior to assembly.
Install bolt (8), and the washer.
Repeat Step 30 through Step 33 for the other side of the ejector bucket.
Illustration 11 g01400121
Apply Tooling (M) to the bore of the ejector cylinder.
Align the bore of the main ejector plate assembly with the bore of the ejector cylinder.
Install shims (5) as required.
Install pin (6) .
Illustration 12 g01103423
Install three caps (23) to the collets.
Illustration 13 g01103424
Install three bungs (24) to the collets.
Illustration 14 g01400119
Apply Tooling (J) to the inside diameter and the outside diameter of the collets.
Install collet (4). Install the collet to the other side.
Apply Tooling (J) to the threads of bolt (3) .
Install bolt (3) and the washer.Note: The collet on one side must not extend farther than the other when the bolt is tight.
Tighten bolt (3) to a torque of 370 50