HARNESS ASSEMBLY-TRANSMISSION 2319379 - Caterpillar

Removal Procedure
Start By:
Release the hydraulic system pressure. Refer to Disassembly and Assembly, "Hyraulic System Pressure - Release".
Remove the cab. Refer to Disassembly and Assembly, "Cab - Remove".
Personal injury can result from hydraulic oil pressure and hot oil.Hydraulic oil pressure can remain in the hydraulic system after the engine has been stopped. Serious injury can be caused if this pressure is not released before any service is done on the hydraulic system.Make sure all of the attachments have been lowered to the ground, and the oil is cool before removing any components or lines. Remove the oil filler cap only when the engine is stopped, and the filler cap is cool enough to touch with your bare hand.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide" for tools and supplies suitable to collect and contain fluids on Caterpillar products.Dispose of all fluids according to local regulations and mandates.
Note: Put identification marks on all lines, hoses, wires, and tubes for installation purposes. Plug all lines, hoses and tubes. This helps prevent fluid loss and contamination of the oil system.
Illustration 1 g01328169
Disconnect fitting assembly (1) .
Illustration 2 g01328171
Disconnect hose assembly (2) .
Illustration 3 g01328176
Disconnect harness assembly (3) and (4) .
Remove cable strap (5) .
Illustration 4 g01328177
Disconnect hose assemblies (6), (7), and (8) .
Illustration 5 g01328178
Disconnect hose assemblies (9), (10) , and ( 11) .
Illustration 6 g01328180
Disconnect hose assemblies (12), (13), and (14) .
Illustration 7 g01328181
Disconnect hose assemblies (15), (16), and (17) .
Illustration 8 g01328184
Disconnect hose assembly (18) .
Illustration 9 g01328186
Remove bolts (19). Remove bank valve (20) and plate (20) from the machine as a unit.
Illustration 10 g01322814
Remove bolts (22). Separate plate (20) from bank valve (19) .