HARNESS AS-ENGINE 2319918 - Caterpillar

Removal Procedure
To facilitate removal of the bucket pins without causing damage to the pins, the bearings, and/or the O-ring seals put the bucket on the floor and the stick in a vertical position, as shown.
Position the bucket, the stick and the bucket control linkage on the ground.
Illustration 1 g00534630Note: Relieve the pressure on the bucket pins by moving the stick up and down.
Illustration 2 g00880305
Remove the nuts and retaining bolt (5) and remove bucket pin (4).
Pull link assembly (1) away from the bucket. Remove two O-ring seals (3).
Remove the nuts and retaining bolt (2).
Illustration 3 g00880306
Remove pin (6) and remove the stick from the bucket.
Remove two O-ring seals (7). Check the condition of the O-ring seals.
Remove bolts (8), plate (9), and shims (10).
Illustration 4 g00880328
Remove flange (11). Check the condition of the flange and dowel (12).
The weight of the bucket is approximately 204 kg (450 lb).