HARNESS AS-SENSOR 2356275 - Caterpillar

TARGET="_parent">Tire Inflation - Check
Every 100 Service Hours or 2 Weeks
Axle Oscillation Bearings - Lubricate
Steering Cylinder Bearings - Lubricate
Initial 250 Service Hours
Transmission Oil Filter - Replace
Every 250 Service Hours
Engine Oil Sample - Obtain
Every 250 Service Hours or Monthly
Battery - Clean
Belts - Inspect/Adjust/Replace
Brake Accumulator - Check
Braking System - Test
Differential and Final Drive Oil Level - Check
Engine Air Filter Service Indicator - Inspect/Replace
Engine Oil (High Speed) and Oil Filter - Change
Engine Oil and Filter - Change
Initial 500 Service Hours
Seat Side Rails - Adjust
Initial 500 Hours (for New Systems, Refilled Systems, and Converted Systems)
Cooling System Coolant Sample (Level 2) - Obtain
Every 500 Service Hours
Differential and Final Drive Oil Sample - Obtain
Hydraulic System Oil Sample - Obtain
Transmission Oil Sample - Obtain
Every 500 Service Hours or 3 Months
Axle Oil Cooler Filter - Replace
Cooling System Coolant Sample (Level 1) - Obtain
Engine Oil (High Speed) and Oil Filter - Change
Engine Oil and Filter - Change
Fuel System Primary Filter (Water Separator) Element - Replace
Fuel System Secondary Filter - Replace
Fuel Tank Cap and Strainer - Clean
Hydraulic System Oil Filter - Replace
Transmission Oil Filter - Replace
Every 1000 Service Hours or 6 Months
Articulation Bearings - Lubricate
Battery Hold-Down - Tighten
Case Drain Oil Filters - Replace
Drive Shaft Support Bearing - Lubricate
Rollover Protective Structure (ROPS) - Inspect
Transmission Oil - Change
Every 2000 Service Hours or 1 Year
Differential and Final Drive Oil - Change
Engine Crankcase Breather - Clean
Engine Valve Lash - Check
Engine Valve Rotators - Inspect
Hydraulic System Oil - Change
Hydraulic Tank Breaker Relief Valve - Clean
Lift Cylinder Pin Oil Level - Check
Loader Boom Pin Oil - Change
Every 3000 Service Hours or 2 Years
Crankshaft Vibration Damper - Inspect
Engine Mounts - Inspect
Every 3 Years After Date of Installation or Every 5 Years After Date of Manufacture
Seat Belt - Replace
Every 4000 Service Hours or 2 Years
Hydraulic System Oil - Change
Every 4000 Service Hours or 2.5 Years
Electronic Unit Injector - Inspect/Adjust
Every 5000 Service Hours or 3 Years
Alternator - Inspect
Lift Cylinder Pin Oil - Change
Starting Motor - Inspect
Turbocharger - Inspect
Every 6000 Service Hours or 3 Years
Cooling System Coolant Extender (ELC) - Add
Every 6000 Service Hours or 6 Years
Cooling System Water Temperature Regulator - Replace
Engine Water Pump - Inspect
Every 12 000 Service Hours or 6 Years
Cooling System Coolant (ELC) - Change