HARNESS AS-LIGHTING 2390237 - Caterpillar

1. Fasten straps and a hoist to cleaner bar (1) as shown. 2. Remove nuts (2) and the bolts from both sides of the cleaner bar. Lower the cleaner bar to the ground.3. Lift the blade and move the machine away from the bar. The weight of cleaner bar is 329 kg (720 lb.)Install Cleaner Bar (Non Engine End-Front)(Blade Installed) (815F)
1. Put the cleaner bar in position under the machine. 2. Fasten the straps and hoist to cleaner bar (1). Make an alignment of the cleaner bar to the machine. 3. Install nuts (2) and the bolts to both sides of the cleaner bar.End By:a. install tag linkRemove Rear Cleaner Bar (Front End)(815F)
Start By:a. remove bulldozer group 1. Fasten a strap and hoist to each side of the cleaner bar. Remove bolt (1) and clamp (2) that hold the oil lines to the cleaner bar. 2. Remove bolts (4). Use two people and remove drive shaft guard (3). The weight of the guard is 63 kg (140 lb.). 3. Remove bolts (5) from both sides of the cleaner bar. Remove the cleaner bar. The weight of the cleaner bar is approximately 531 kg (1180 lb.).Install Rear Cleaner Bar (Front End)(815F)
1. Make an alignment of dowels (1) and the machine. Install the cleaner bar. 2. Install drive shaft guard (2).End By:install bulldozer group.