HARNESS AS-REAR CHASSIS 2416066 - Caterpillar

Removal Procedure
Table 1
Required Tools    
Tool     Part Number     Part Description     Qty    
A     367-3534     Oil Seal Removal & Installer Tool     1    Start By:
Remove the crankshaft pulley. Refer to Disassembly and Assembly, "Vibration Damper and Pulley - Remove" for the correct procedure.
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Illustration 1 g03344801
Position Tooling (A) onto crankshaft front seal (2) .
Turn Tooling (A) in a counterclockwise direction and remove crankshaft front seal (2) from front cover (1) .Installation Procedure
Table 2
Required Tools    
Tool     Part Number     Part Description     Qty    
A     367-3534     Oil Seal Removal & Installer Tool     1    
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Ensure that the front cover is clean and free from damage.
Illustration 2 g03344801
Correctly position a new crankshaft front seal (2) in Position (X) onto front cover (1) .
Position Tooling (A) onto crankshaft front seal (2) .
Use Tooling (A) in order to turn crankshaft front seal (2) in clockwise direction.
If a torque greater than 50 N m (37 lb ft) is necessary, in order to install crankshaft front seal (2) . Remove crankshaft front seal (2) . Inspect the crankshaft front seal and the front cover for faults or damage.
If necessary repeat Step 2 through Step 5 in order to install crankshaft front seal (2) .End By: Install the crankshaft pulley. Refer to Disassembly and Assembly, "Vibration Damper and Pulley - Install" for the correct procedure.