HARNESS AS-WIRING 2420083 - Caterpillar

Installation Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
(A) 138-7575 Link Bracket 4
Illustration 1 g00547270
Put shims (12) in the original locations on the frame of the machine.
Illustration 2 g00547269
Typical example
Fasten Tool (A) and a suitable lifting device to the hydraulic oil tank (11), as shown. Put the hydraulic oil tank in position on the frame of the machine.
Illustration 3 g00547265
Apply 9S-3263 Thread Lock Compound on the threads of four bolts (2). Install the spacers and four bolts. Tighten the four bolts to a torque of 270 40 N m (200 30 lb ft).
Connect hose assembly (3) to the pipe. Install clamp (5).
Be sure that drain plug (4) is tight.
Illustration 4 g00547267
Install the return hoses (13) and (14) in the T-Fitting.
Connect oil return tube (8) to the hydraulic oil tank with the four washer and bolts (7).
Illustration 5 g00558864
Connect wire (6) to the oil level sensor that is located on the side of the hydraulic oil tank.
Illustration 6 g00561285
Install cover (10). Install the four washers and the four bolts (9).
Fill the hydraulic oil tank with oil to the correct level. Refer to Operation and Maintenance Manual, "Hydraulic System Oil Level - Check", Operation and Maintenance Manual, "Hydraulic System Oil - Change" and Operation and Maintenance Manual, "Refill Capacities". End By:
Install the fuel tank. Refer to Disassembly and Assembly, "Fuel Tank - Install".