HARNESS AS-CAB 2510597 - Caterpillar

Pressurized System!Hydraulic accumulators contain gas and oil under high pressure. DO NOT disconnect lines or disassemble any component of a pressurized accumulator. All gas pre-charge must be removed from the accumulator as instructed by the service manual before servicing or disposing of the accumulator or any accumulator component.Failure to follow the instructions and warnings could result in personal injury or death.Only use dry nitrogen gas to recharge accumulators. See your Cat dealer for special equipment and detailed information for accumulator service and charging.
Note: When the ride control accumulator is properly charged, the bouncing motion of the machine is reduced by the ride control accumulator.
Put a typical load in the bucket.
Press and hold the ride control switch in order to activate the ride control service mode.
Drive the machine over a rough road surface. If the machine bounces too much or the accumulator piston striking the stop can be heard, consult your Caterpillar dealer or refer to Service Manual Testing and Adjusting, "Ride Control Accumulator - Test and Charge".